Product Information

+10% / 15%

The Rubik’s Cube is still a very popular puzzle toy. The fact is that it’s even more popular than in the 80’s.

Single Channel Loop Detector

Usage of Loop Detector:
The APC-LD1 is a loop detector sensor module that is used wherever vehicles need to be detected. The loop detector can be connected to any of the following types of systems that allow the use of a loop detector:
- Driveway Gate Mechanisms
- Operating Barrier Mechanisms
- Traffic Light Systems in car parks

How it Works:
The loop detector is housed in the controller box/enclosure of the connected mechanism and is used to communicate with the underground inductive loop wire when a vehicle is detected which then sends a signal to the connected system to open the mechanism, close the mechanism or prevent the system from closing.

Specifications

Voltage:

24V AC/DC

Voltage Tollerance AC:

Voltage Tollerance DC:

+/ 15%

Power Consumption:

4.5VA

Output Relays:

240V/5A

Frequency Range:

20 kHz to 170 kHz

Reaction Time:

10ms

Signal Holding Time:

Unlimited, Limited when loop is permanently covered

Sensitivity:

Adjustable in 4 increments

Wiring:

Recommend 100μH to 300μH

Operating Temperature:

-20°C to +65°C

Storage Temperature:

-40°C to +85°C

Approximate Loop Sizes
Driveway Width	Loop Size
3m – 4.5m	1.8m x 1.2m
4.8m – 5.4m	2.4m x 1.2m
5.8m – 6.7m	3m x 1.2m
7m – 7.9m	4.3 × 1.2m

Single Channel 24V Induction Loop Detector(QTY: 1)
40m Roll of Teflon Insulated Induction Loop Cable(QTY: 1)

This product is sold by a third-party seller and they are responsible for their product, the content of their listing and any exchanges of return of their product.

All products sold by third-parties are subject to the Customer Charter and comes with guarantees that cannot be excluded under the Australian Consumer Law.